Armature giấy cách điện máy

Malfunction

Check

A Failure to start

Power and air supply

Make sure all input signal from sensor are correct, travel switch (X10) is pressed, no signal from counter sensor (X2), push bar protector (X7) and no paper sensor(x6) and full feeding (X4), Also, there is signal from the mechanical hand (X0) and magnetic sensor (X1) of small cylinder.

Brake is power off or not.

The feeding sensor (X3) should have signal if there is rotor on the guide way.

Check cylinder and air pipe, make sure the pressure is between 0.4 and 0.6MPa.

B. Can`t feed paper

Check whether the paper is jammed in the feeding or discharging part, whether the upper press wheel is down pressed.

C No action or

improper action in big cylinder

Make sure the air pressure is 0.4~0.6MPa.

Check whether the magnetic valve is functional.

Adjust the release valve of feeding cylinder to 0.3 Mpa.

D Incorrect work indexing

Adjust indexing screw.

E No action in small cylinder

Check whether the mechanical valve is down pressed.

F The position is not correct after reset

Adjust the counter sensor screw and make sure it is on the right position after reset.

G Paper jam

If it was blocked in the forming tooling, the equipment would stop because the protective switch is on duty. If it was blocked behind the upper press wheel, press the stop button, now the mechanical hand still hold the rotors, press the single/automatic button to adjust it to manual, the mechanical hand will release the rotor, then take out the paper, and reset, adjust the button to automatic, and start the equipment.